|
|
|
|||||||
|
#1
04-12-1999, 07:19 PM
|
|||
|
|||
will the new Dakota 8 1/4 rear end center section fit in a 1978 Dodge Aspen 8 1/4 rear end?
|
|
#2
04-20-1999, 04:43 AM
|
|||
|
|||
|
I think so. In 77 the carrier bearings got a little bit larger in diameter than previous years. I do not think its changed since. even if it has you can remove a bearing of the wrong size and press on with the size you need. Just order the same Timken Part#. The people at http://www.ring-pinion.com may be able to give you a more definite answer but I would bet you could.
|
|
#3
04-20-1999, 05:05 AM
|
|||
|
|||
|
If your reffering to what the service manual calls a "carrier"(the part that the ring gear attaches to.)yes it will fit.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8 3/4 center section | 63Fury | Rear Wheel Drive - Parts Wanted | 4 | 01-23-2009 07:57 AM |
| Rear center section wanted | pontiac jack | Rear Wheel Drive - Parts Wanted | 1 | 05-12-2007 12:08 AM |
| 8 3/4 center section | Mudologist | Rear Wheel Drive - Parts for Sale | 1 | 09-10-2006 10:33 PM |
| 489 center section | Manning | Rear Wheel Drive - Parts for Sale | 1 | 12-23-2005 10:54 PM |
| 8 3/4 rear center section- 4.56 or steeper | Marc | Rear Wheel Drive - Parts Wanted | 5 | 11-09-2003 10:38 PM |
Linear Mode
