|
#1
|
|||
|
|||
440 Preformer RPM intake?
The Performer RPM intake on my 440 "70 Cuda is just a little to close to the hood. Has anyone every milled some stock off the carb mounting pad to gain some more clearance? I really don't like the look of the lower Performer manifold but I could really use at least 1/2" more clearance. I'm not even sure if it's possible to mill that much off this manifold.
|
#2
|
|||
|
|||
clearance, Clarence
Have you considered that you will reduce the low end torque at the lower height? How much room do you have? Maybe a lower air cleaner will solve the issue. You did not say what the present clearance is, so I'm guessing here.
Ron |
#3
|
|||
|
|||
I have the same manifold on my 440 GTX and the same problem with the unsilenced air cleaner. My local NAPA let me sniff around his selection of air filters. I found one that was the same diameter but not as tall. I picked up the clearance I needed that way. Mark
|
#4
|
||||
|
||||
There are some good drop base air cleaners out there. I used to use a 2" drop in my 64 before I put the scoop on. 440 with rpm manifold.
I don't think you will be able to mill much off. my .02 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
340 intake vs 318 intake, what works best for this.... | poomwah | Performance Talk | 17 | 09-30-2007 06:33 PM |
M-1 Intake or Modify Stock Intake? | adamjmc | Ram Truck Chat | 8 | 01-12-2003 01:06 PM |
Mopar MPI Intake VS Hughes Engines Modified Intake | bootleg | Ram Truck Chat | 17 | 12-07-2002 09:51 AM |
Is there Regular Intake and Cold air intake? | 01MagnumV6 | Dakota Truck Forum | 1 | 04-23-2002 12:18 AM |
AirRaid intake vs. QuickD intake vs. KN Gen II | TruckBoy95 | Ram Truck Chat | 23 | 09-10-2000 03:33 AM |