|
#1
|
|||
|
|||
Piston/Head question-big block
Is anyone using Speed Pro piston #L2295F with Edelbrock Performer RPM head #60929? This is the 84cc quench style aluminum head. I'm wondering if there are any interference issues because of the dome on the piston.Thanks,......djs
|
#2
|
|||
|
|||
Those were the pistons that I was using with my 906's, which had been milled and I was running .038" head gaskets, with no interference issues. I don't think the 84cc Eddy's will be any problem.
|
#3
|
|||
|
|||
thanks Rampage. I've used them with 906 heads too. Just wondering if anyone else might have used them with the Eddy's.............djs
|
#4
|
|||
|
|||
Don't forget to check it before you bolt it together....
|
#5
|
|||
|
|||
I'm running a 10cc dome with 81cc Eddys.I also clayed the chambers and had .195" clearance.
|
#6
|
|||
|
|||
And still got lot's of room to cut....
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can I use thicker head gasket if piston is too far out of the block? | ramcharger_440 | Performance Talk | 17 | 02-06-2007 09:58 AM |
big block cylinder head question | 66b-body23 | Vintage MOPAR chat | 5 | 08-06-2005 02:14 AM |
383 block ,906 head question | 19cuda67 | Performance Talk | 8 | 07-07-2003 11:14 PM |
Big Block Edelbrock head question | rumblefish360 | Performance Talk | 19 | 09-07-2001 07:40 AM |
big block head question | 383RRwill | Performance Talk | 2 | 03-07-2000 05:26 AM |