|
#1
|
|||
|
|||
shock mounts
The 81/4 rear end I got out of the junk yard had no shock mounts but it did have the u-bolts and there in good shape, can I drill out the mounts from my 71/4 to accept the larger u-bolts? Also from what Iam finding is my driveshaft has to be shortened 1.5 inches for this swap into my 68 Barracuda??
|
#2
|
||||
|
||||
I have been told you can drill the shock mounts out for this. I haven't myself. I picked up new ones at just suspesion. I think Mancini racing also has them. I liked new rather than modded old units.
The 1-1/2 is the measurement I got from a 904 to a 727 swap I did. |
#3
|
||||
|
||||
I've drilled a few of them and they work just fine. Drill bits a lot cheaper, but you can buy new pieces.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shock mounts | ibcuda | Performance Talk | 2 | 05-06-2008 10:54 PM |
75 dart suspension top shock mounts are worn out | motown hot rod | Performance Talk | 1 | 01-21-2005 09:34 PM |
Solid motor mounts vs. rubber mounts | megore | Performance Talk | 9 | 12-18-2001 07:38 PM |
Pictures of your Cb Antenna Mounts, and Radio Mounts inside...!??? | Snopro7c | Ram Truck Chat | 3 | 12-06-2001 08:41 PM |
Solid motor mounts vs. rubber mounts | megore | Drag Racing Forum | 3 | 12-27-2000 06:50 AM |