|
#1
|
||||
|
||||
cheap bb roller rockers??
where can i find inexpensive bb roller rockers?? i had an old mopar mag and they had an advertisement for roller rockers for $130.00 i called em and they didn't carry mopar parts anymore, and was wondering where i could find em??
|
#2
|
|||
|
|||
check out 440source.com
|
#3
|
|||
|
|||
If your dead set to have aluminum rockers..............
Then there are plenty there. For street I would use the iron mechanical rockers. You do know that the roller tips on the aluminum rockers don't roll? Therefore the only advantage is if the rollers at the shafts roll. For instance, I always thought the advantage went to iron mechanical rockers. After all, they will last till your grandkids are grown.
|
#4
|
|||
|
|||
The only cheaper rockers out there that I know to be street worthy and not fall apart are OHIO CRANKSHAFT NEEDLE BEARING TYPE they cost $139 set and require harland sharp adjusters 7/16 $90 and rocker specialties shafts$105 set
the rocker specialties shaft are super THICK WALLED and rule! so the least expensive HIGH QUALITY roller rocker arms cost $139+$90+$105=$334+tax And they come 1.5 or 1.6 |
#5
|
|||
|
|||
I like Crane!
|
#6
|
|||
|
|||
Crane Gold rockers aren't cheap @ $450 +, but they are good.
|
#7
|
|||
|
|||
Quote:
|
#8
|
|||
|
|||
ball/cup push rods are used with the harland sharp adjusters.
never did like the idea of ball/ball push rods due to the fact that they hold no oil at the rocker/adjuster =heat/wear. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Roller rockers | v8kyze | Performance Talk | 2 | 09-04-2009 11:23 AM |
Cheap ($165) BB 1.6 Roller rockers | pylut | Performance Talk | 0 | 05-04-2002 08:07 PM |
Roller rockers vs regular adjustable rockers | 65 racer | Drag Racing Forum | 2 | 04-27-2001 12:49 AM |
Roller rockers vs regular adjustable rockers | 65 racer | Performance Talk | 2 | 04-26-2001 03:07 AM |
Rockers: roller tipped alone VS full roller | MopART | Performance Talk | 8 | 01-28-2000 07:00 PM |