|
#1
|
|||
|
|||
451 B block head gasket with B1/BS heads
Any suggestions? I would like to use the Mopar Performance #312-P5155237 steel gaskets but appears to be too small bore size 4.380" I am at 4.410"
|
#2
|
|||
|
|||
Try Mopar Pn P4876070 with a Steel Block alum head you Will like this one better dont forget retourge heads after intial run in.Figure the valve LashAt .. .006 to .008 less and set it cold.
|
#3
|
|||
|
|||
These are also for 4.380 bore. Is this the minimum bore? if so both Mopar Pn P4876070 and P5155237 will work.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Head Gasket? | Sterling | Neon Club Chat | 5 | 03-09-2009 03:18 PM |
Can I use thicker head gasket if piston is too far out of the block? | ramcharger_440 | Performance Talk | 17 | 02-06-2007 09:58 AM |
Head studs and head gasket | Magnum14 | Front Wheel Drive Chat | 4 | 04-27-2006 04:57 AM |
Blown head gasket,small block | DUSTER340 | Performance Talk | 6 | 04-19-2002 09:36 PM |
Felpro head gasket PN# for 10-1 360 SB And edelbrock heads | 78 Red Express | Performance Talk | 1 | 02-27-2002 09:56 PM |