|
#1
|
|||
|
|||
408 stroker
planing on a 408 build using eagle h beam rods. do u have to notch the block for clearance
|
#2
|
|||
|
|||
with H beams ...Yes..bottom of bore to clear rod bolts..
with Scat 4340 I beams ....NO notching needed. |
#3
|
|||
|
|||
We just built 1 "340 six pack" with a muscle motors stroker kit, cast crank, Hypereutectic pistons and Eagle I beams. It's got a mild comp cams hydraulic flat tappet, 9.5:1 CR and tweaked here & there a little. Run it in and tuned it last saturday in the dyno, worked perfect. Made 409 hp with exhaust manifolds through the mufflers.
http://www.youtube.com/watch?v=heDqU7af-lc |
#4
|
|||
|
|||
thanks figured I probably would but was hopeing not
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stroker | jtmoney | Dakota Truck Forum | 63 | 10-02-2002 07:00 AM |
318 stroker | TrxR | Performance Talk | 26 | 09-13-2002 12:01 AM |
360 Stroker | TrxR | Performance Talk | 9 | 08-06-2002 08:22 AM |
360 stroker | bobbyg | Performance Talk | 1 | 05-27-2001 08:56 AM |
Eagle 'RB' 4.15 Stroker Crank VS. MP 4.15 Stroker Crank VS. Welded Stock Steel | krownman | Performance Talk | 5 | 03-04-2001 11:47 PM |