PDA

View Full Version : header advice 360


breaux
01-19-2013, 11:16 PM
just picked up a mopar 360 that i am going to put in my 1968 dart. wondering if anybody could recommend some headers that are going to fit without any trouble.

also other then the engine mounts are there going to be any unforseen complications with the install? any pieces in the way that need to be removed, stuff like that.

this is prob not the right place to post this, but i also have a 1972 dart body that i am trying to get rid of. pretty good shape, but i am pulling the engine and tranny from that so it would be sad to see it head off to the scrap yard : (

and last but not least, wondering if the slant six from my 68 will fit directly into the 72?

thank ya all for the advice : )

te.ringer
01-20-2013, 09:45 AM
what engine was in there to start ?could have k frame problems,if you can't get the right engine mounts,water pump left or right side inlet, wrong or larger needed radiator. a 360 la or mag. just some things I might ask before you get started.

aarracer
01-20-2013, 02:33 PM
TTI headers are probably the best, but expensive. Most others are low slung and a dented tube looking for a place to happen!

Letsrace
01-24-2013, 10:46 PM
TTI x2

The tech support at TTI is outstanding, give them a call. I am using a kevko rear sump pan in my 360. I called TTI for fitment questions. They actually called Kevko for measurments and called me back. I will gladly pay a little extra for good tech support

You may need aftermarket motor mounts for the slant 6 install. Need to know which k frame it has. Go to Mancini Racing they have conversion mounts for the different applications.
It wont let me post links to the above. Post count too low????
Good luck