|
|
|
|||||||
|
#1
02-05-2001, 09:19 PM
|
|||
|
|||
Can someone that owns 1 give me the exact hole size for the cylinders,I have the 2"
steel plates ready to go just need the sizes. 
|
|
#2
02-06-2001, 05:26 AM
|
|||
|
|||
If I can make a suggestion- leave enough meat in your plates to incorporate the 18 head bolt pattern for the small block. There arn't a lot of these race blocks out in the mainstream yet but there will be in the future. I would make your bore hole 4.200" since the race blocks will safely bore that far.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flex plate/torque converter | garyhairr | Ram Truck Chat | 4 | 02-25-2011 06:13 PM |
| torque plate trouble | gdking | Restoring your MoPar (Tricks & techniques) | 2 | 10-10-2010 12:23 PM |
| Torque Plate hone | it's all dodge | Performance Talk | 8 | 02-18-2007 11:32 PM |
| 440 Torque Plate | Hard_ChargerR/T | Performance Talk | 12 | 04-05-2002 08:50 PM |
| Torque Plate for Boring 340?? | Plum Crazy Chris | Performance Talk | 9 | 09-06-2001 11:46 AM |
Linear Mode
