homemade flow bench, any luck?

[motorhead440]

Did anyone have any luck opening the flow bench article i sent out? If not i will make copies and send them to you if you provide a mailing address at my e-mail. Here is my e-mail address jeffl@netnitco.net

------------------
It's better to have been a participant once, than a spectator a lifetime!

[Christopher]

I sent you a message via e-mail.

[Beeracuda]

I didn't have any trouble opening it. Thanks for sending it.

Monty

[451duster]

I never did figure out how to open it. I will send you my address via e-mail. If you return your address I can send you a SASE.
Thanks,
Scott

[Krep]

I got mine and it works great. You need at least four-2 hp vacuums or one very large one to make it work proprerly. I made my unit smaller than the eg.(don't have much shop space). If anybody runs AutoCad and you would like a template of all the scales and a blueprint of my bench, I can E-mail them to you. Thanks again for the effort in sending everybody that magazine article.

[451duster]

Krep,
I would like to take you up on that offer. My email address is ///////////@yahoo.com.
Thanks,
Scott

[ChristianCuda]

Krep I too would like the Autocad files

Christian

[knurkl]

Krep, I'd really appreciate a copy of those files, too. rdv@chello.nl
Thanks

[mopardude]

Hey KREP! whats your email address? You almost live next door to me wow another canadian kool!

[Krep]

Hey Mopardude, I was just in Niagra Falls a couple of weeks ago. Tried to stick it rich at the Casino (not a good idea). Your right about the Canadian Mopar bit. All I see around here is Mustang's and Camaro's.skroeplin@freure.com