|
|
|
|||||||
|
#1
03-28-2000, 12:15 AM
|
|||
|
|||
Does anyone know of a shop or company which sells 4.125"-4.25" welded strokers made on stock cores?I considered having one done locally, but was conerned about the heat- treat issue. It would be for a street-strip eng. and would probably never see the high side of 6000R.P.M.
------------------ [This message has been edited by moparking (edited March 27, 2000).] 
|
|
#2
03-28-2000, 10:13 AM
|
|||
|
|||
|
I had a 4.25 crank done by "Pauls" http://www.devtex.net/paulscrankshop/
[This message has been edited by nick s (edited March 28, 2000).]
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MP Stroker cranks | stretch_360 | Performance Talk | 1 | 08-25-2001 01:39 PM |
| Eagle 'RB' 4.15 Stroker Crank VS. MP 4.15 Stroker Crank VS. Welded Stock Steel | krownman | Performance Talk | 5 | 03-04-2001 11:47 PM |
| Welded Stroker from Paul's Crank Shop | Streetwize | Performance Talk | 5 | 01-12-2001 05:11 AM |
| welded stroker crank B/RB | moparking | Performance Talk | 1 | 03-23-2000 03:56 AM |
| Welded stroker cranks | mopardude | Performance Talk | 2 | 03-17-2000 03:35 PM |
Linear Mode
