|
#1
|
||||
|
||||
Well my balancer keeps taking out the front seal and making a leaky mess on my 440. Going off from memory it seamed that their was a sheet metal sleave that slipped over the balancer shaft. The seal then road on this sleeve, well the sleave looking deal was pretty distorted looking and I think is the problem. So the question is, is what I saw right? And can you replace this with out getting a new balancer? I looking in the MP book and see no such thing.
|
#2
|
|||
|
|||
I recently read an article about resleeving kits for damper shafts in one of the car magazines. I can't remember who makes them, but it seems to me it was something you could pick up at an auto supply store. The article included a step by step "how to" installation series - dam - I'm getting old cuz i cannot remember which mag it was...anyone else see this?
|
#3
|
||||
|
||||
Yes it was in an old Mopar Muscle. I wanna say within the last two years. I don't have too many 2000 issues, but I do have quite a bit of 1999 articles. You are correct, it was a pressed in sleeve that was installed. I'll check at home tonight.
|
#4
|
||||
|
||||
Thanks for your help on this, anything you can find would be great. I really want to buy a fluid damper, but I already have to buy a new fuel system before the end of April, and like alway cash is short in supply.
|
#5
|
|||
|
|||
Found It!
It was in the July 2000 issue of Mopar Muscle - It's a FEL-PRO part, Check your e-mail. I emailed you at the address shown on your truck site. Hope that is right.
Bitchin' truck by the way - it looks like a lot of fun! |
#6
|
||||
|
||||
They are commonly referred to as a "speedy sleeve", you should be able to get one from a good auto parts store.
|
#7
|
||||
|
||||
Thanks, I got it, Just what I needed!!
|
#8
|
||||
|
||||
Better late than never...for the rest of us wondering...check sleeve n seal (fel-pro)
|
#9
|
||||
|
||||
Just went through and actually red that and the way it sounds their is no sleeve on the factory unit? The reason I ask is because I am almost positve that mine has a sleeve on it. And if it does I would think it would take a slightly different size seal? I have been using a stock replacement seal, maybe the fit is a bit tight.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
harmonic balancer | lxrubin | Performance Talk | 4 | 11-04-2008 01:31 PM |
Harmonic Balancer help! | bwidner | Vintage MOPAR chat | 14 | 03-24-2007 02:11 PM |
Harmonic Balancer | maxb45678 | Performance Talk | 7 | 08-04-2003 12:44 PM |
Which 360 Harmonic balancer? | PINK71T/A | Performance Talk | 2 | 01-15-2003 05:02 PM |
340 = 318 harmonic balancer | Plum Crazy Chris | Performance Talk | 6 | 09-26-2001 09:53 PM |