|
#1
|
|||
|
|||
I am ready to put my MP valve covers on my 383 now, but the studs are not long enough. How do I remove the studs in order to replace them with something else? Do I just put some vice grips on them and unscrew them...is it as easy as that?
|
#2
|
||||
|
||||
Best way is take two nuts and screw them down on the stud until top nut is flush with top of stud, use two wrenches and tighten nuts against each other then turn both counterclockwise and stud should come right out.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mp valve cover | bulldog426 | Performance Talk | 5 | 04-20-2010 09:37 AM |
valve cover oil cap- 340 | riverside | Rear Wheel Drive - Parts Wanted | 0 | 09-10-2006 02:36 PM |
valve cover | oibrownskin | Slant Six Chat | 4 | 06-15-2004 09:31 PM |
Valve Cover | Dart 65 | Front Wheel Drive Chat | 0 | 06-18-2003 11:27 PM |
valve cover hold-down - bolts vs studs | jhixson | Restoring your MoPar (Tricks & techniques) | 1 | 10-15-2001 11:25 PM |