FENDER VIN TAGS

[moparsofcamelot]

Anyone know where I can get a fender tag made? I'm not trying to pass the car off as something it's not. It's a 64 Polara that Galen Govier says is a 383 2 barrel equiped with the usual stuff. I'm not trying to get it certified, just get a fender tag reproduced to go where I don't have one. You see I already have a 69 440 4 barrel in it. I also have a new 6 pack setup I got from Mancini. Can anyone help. P.S. While I'm on the subject, I remember when the 6 packs came out in 69 1/2 (I was driving then), right off the show room floor the 6 pack would hesitate a split second before launching when floored. Do we know something in the 90's that we did'nt know in the 60's that can eliminate this?
Thanks, moparsofcamelot.

[Christopher]

I don't know of anybody reproducing fender tags.In fact I think it's illegal to do so.As far as the 440+6 hesitation,these carbs were set up lean from the factory and a increase in jet size and a power valve change,(depending on cam selection)with sometimes a vacuum diaphragm spring was all they needed.It really is a good setup once it's tuned properly.The 440+6 really responds with fresh air to the Holleys,so that's important too.

[cudadude]

For some of the best advice and parts for a six pack set up contact a place called SIX PACK's To Go INC. Their address is 1807 Overlake DR. Suite A, Conyers GA. 30013. I do not have their phone # handy at this moment but i do know that their progressive linkage kit with some minor carb tuning will create a very wicked pulling set up.

[Sheg]

To the best of my knowledge Galen Govier has the ability to reproduce tags and also has tags that could be for your car. Did you ask him about the tags?