|
#1
|
|||
|
|||
Hello everyone, I,m a partime dragracer but mostly ratrasing around. I have 73 barracuda with 3.55 gears and installing 3.91,s. I also have 26 inch hoosier slicks for the track. My question is where is the best possible spot to mount a lakewood driveshaft safety loop? I realize I might not need one but hey with slicks you never know. I looked at mounting at transmission mount but theres no way as I would have to add on to the loop and it would make it to weak. I do not mind bolting it through the floor but it would be nice if it came up under the seat or something. Is there a proper spot for it or do you just make it fit wherever you can.? There is a 727 trans in the car. Thanks replys would be greatly appreciated. Tim
|
#2
|
|||
|
|||
My U-joint bolts snapped a few days ago leaving the muffler shop...damn wished i had a safety loop installed..what's the best one out thier..? is the bolt in version good or the welding version?
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drive Shaft Safety Loop | Mopard | Rear Wheel Drive - Parts Wanted | 0 | 02-12-2013 04:00 AM |
Back in the loop! | LadyGTX | Vintage MOPAR chat | 4 | 05-14-2006 02:07 PM |
Driveshaft loop | FASTDARTCHESTER | Performance Talk | 2 | 09-12-2003 05:01 PM |
Out of the Loop | Clears | Dakota Truck Forum | 0 | 09-17-2002 10:40 AM |
driveshaft loop | slepr1 | Performance Talk | 1 | 08-01-2000 08:23 AM |