|
#1
|
|||
|
|||
Has this been talked about yet . Has anyone here off set ground a 360 crank and used small block chev rods and a stroker pistons. I hear you can make around 400 cu in . A guy at the local track built one and is running mid 11 sec with a 1970 dart street car @ 3000 ft altitude.
|
#2
|
||||
|
||||
Tried and true. Works great. Best to keep revs under 6500. Most around here offset grind .125"
|
#3
|
|||
|
|||
dont forget MP has a 4" stoker crank new,its cast for around $349...PRO...
|
#4
|
|||
|
|||
You would have to use a small journal chevy rod because the large journal is only like .030 smaller than a dodge.
I have a destroked engine that was run in comp eliminator using small journal chevy rods, but they only destroked it to 3.21. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stroker | jtmoney | Dakota Truck Forum | 63 | 10-02-2002 07:00 AM |
318 stroker | TrxR | Performance Talk | 26 | 09-13-2002 12:01 AM |
360 Stroker | TrxR | Performance Talk | 9 | 08-06-2002 08:22 AM |
360 stroker | bobbyg | Performance Talk | 1 | 05-27-2001 08:56 AM |
Eagle 'RB' 4.15 Stroker Crank VS. MP 4.15 Stroker Crank VS. Welded Stock Steel | krownman | Performance Talk | 5 | 03-04-2001 11:47 PM |