|
#1
|
|||
|
|||
400hp 440 build up
i have a 75 440 with closed chambered heads , edelbrock performer rpm intake , comp cam 230 @ .050 480 lift, hooker headers , street avenger holley 770 carb. what kind of 1/4 times can i expect from this combo with a 2500 stall in a 74 roadrunner with a 3.23 gear.
|
#2
|
|||
|
|||
Without knowing all the details, maybe mid to high 13's. The '71-74 "B" body care are fairly heavy, probbly #3,800 or more. Just put it together, tune it up, and take it to the track
Once at the track you should be able to tune the engine for even better performance. |
#3
|
|||
|
|||
Hey DAN-THE-MAN, checkout the last 3 issues of Mopar Muscle mag. On the cheap they built a street 440 pulling 666HP@6600RPM and 622ft/lbs@5000RPM. 915 heads(same as yours), 2.25 Manley intake valves,1.81 exhuasts, porting on the heads. Junkyard block .060" over, regound stock forged crank, Eagle H-beam rods, Arais 12.5:1 pistons, Total Seal Slant Gap Gapless rings,copper O-ring gaskets for heads. You might not do the whole deal, but it should give you some ideas where to spend you next year's paycheck.
|
#4
|
|||
|
|||
Dan, you didn't mention the compression ratio or the specifics on the heads, but I am guessing low 14s. Those 3.23 gears don't help. Also, I presume you are running a trans cooler. A 2500 RPM stall with a 3.23 rear axle is going to generate a lot of heat.
|
#5
|
|||
|
|||
the compression should be 9 to1
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
400HP 318 First Engine Build | BlackAce | Performance Talk | 62 | 12-12-2005 12:34 AM |
can I get a 350-400hp 318? | 74 DART SWINGER | Performance Talk | 18 | 10-02-2003 05:33 PM |
400HP from a 318? Yikes!!!!!! | vanderkwv | Performance Talk | 52 | 09-09-2003 08:58 PM |
87 dakota 360v8 400hp | morris minor 60 | Dakota Truck Forum | 3 | 03-06-2003 02:57 PM |
getting to 400hp | Ibr8k4vetts | Performance Talk | 5 | 11-18-2001 12:03 PM |