|
#1
|
|||
|
|||
Bore Out 413
I WAS WOUNDREING HOW FAR I CAN BORE OUT A 413. CAN I BORE IT OUT TO A 383.
|
#2
|
|||
|
|||
Re: Bore Out 413
Quote:
|
#3
|
||||
|
||||
Sorry guys a 413 has a bore size of 4.187. I have read that the blocks were made with the same cores as a 440. If thats the case then I would assume you could punch it out the same as a 440, but why?
|
#4
|
|||
|
|||
I HAVE A SET OF 426 HEADS I WOULD LIKE TO PUT ON IT. I ALSO HAVE PISTONS. IT WOULD BE A POOR MANS HEMI
|
#5
|
||||
|
||||
I wouldn't bore it out too far, .060 is likely max. The sleeves will not be the same as a 440 even if the block is the same. If you have the parts you could modify the block to accept Hemi heads.
|
#6
|
||||
|
||||
Sleeves in a iron block? They sure don't leave the factory like that. If you are talking about putting Hemi heads on a wedge block have fun putting in the fifth head bolt. If your talking wedge heads they will bolt onto a 413 at std bore size.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
360 eng max bore | daveashsr | Circle Track Chat | 3 | 10-19-2015 03:52 PM |
413 Re-bore | Greg55_99 | Performance Talk | 14 | 08-17-2007 05:51 PM |
over bore on a 340 | chrisw21_2000 | Performance Talk | 10 | 11-23-2006 10:38 PM |
GO over .060 bore? and a few other ? | ITHURTZ | Performance Talk | 8 | 10-19-2006 04:25 PM |
spread bore to square bore carb adapter... | creative1 | Performance Talk | 2 | 10-30-2003 01:35 PM |