|
#1
|
|||
|
|||
ignitor electronic ignition question
when the ignitor says it fits all small blocks does it fit the 318 poly too? or does the poly need a special ignitor? i have to change the points soon and i am opting to go with this instead.
|
#2
|
||||
|
||||
The Pertronix Ignitor is set up to be a replacement for the current points and condensor. If your using the same points as the a-block 318, you should easily be able to do the swap. It uses the same mounting screw as the points and set the gap for the pickup at 30. Red wire to coil+, black to coil-. Your done. So long as you can set the gap at 30, your good I think.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electronic ignition question | jeff black | Performance Talk | 2 | 10-07-2004 01:17 AM |
Electronic Ignition question | 84ram | Performance Talk | 3 | 06-01-2004 08:32 AM |
Electronic Ignition Question? | Edlanta | Performance Talk | 3 | 07-09-2003 04:42 PM |
AutoMeter Tach with MP Electronic Ignition question | 68Valiant | Performance Talk | 2 | 03-31-2001 08:00 PM |
IGNITOR VS MP ELECTRONIC IGNITION | CHARGERVH | Performance Talk | 0 | 05-10-2000 09:26 PM |