|
#1
|
||||
|
||||
Honing lifter bore, what to use?
My engine is coming apart soon for a good inspection and likely new rings and bearings. I want to run something through the lifter bores to make sure they are clean. I was on the Mac tool truck today and see they have small cylinder honers and flex hones. The flex hone I figure would be better but the 2 sizes close to the lifter are the 15/16 and 1 inch ones. Which one? Also
what grit, they range from 80-320. Thanks |
#2
|
||||
|
||||
I don't know if this is the right one to use, but I've used a brake wheel cylinder hone.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
lifter bore spec | daveashsr | Circle Track Chat | 5 | 01-29-2009 08:46 PM |
lifter bore cl s/b | daveashsr | Performance Talk | 7 | 01-24-2009 03:31 PM |
s/b lifter bore cl | daveashsr | Circle Track Chat | 3 | 01-24-2009 03:02 PM |
lifter bore clearance? | ply426 | Performance Talk | 1 | 08-19-2002 04:15 PM |
Lifter Bore Question | moparmac | Performance Talk | 3 | 01-15-2002 08:03 PM |