|
#1
|
|||
|
|||
Does anyone know where 3-1/2 in. or larger exhaust pipes can be purchased? Jegs & Summit only carry 3.0 in. and all the local muffler shops usually carry only 2-1/2 max!
My last 3 in. was mandrel bent by Meineke Muffler but they don't go any larger. Mike |
#2
|
|||
|
|||
Try: www.burnsstainless.com
They have a limited amount of the bigger stuff in stock, but if you have the time I'm sure they could accommodate your other requests. I've used their 304 3" SS for my system. |
#3
|
|||
|
|||
How about PETERBILT?? Yuk Yuk
|
#4
|
|||
|
|||
I have used big truck exhaust parts, they work just fine. The only problem is that they are very heavywall stuff (.080")and weigh alot.
|
#5
|
|||
|
|||
I had a muffler shop put my 3.5" exhaust on.
This shop does alot of larger trucks too. The problem is the tube is not mandrel bent, and exits at the rear axle. I think the mandrel bent 3" system from TTI would probbly flow almost the same, at least on the 451 stroker I don't expect to loose much performance when I put the 3" system on. The benifit is the 3" system exits out the back over and is quieter. Borla has some neat oval tubing too for extra ground clearance, usually used by the circle track guys. |
#6
|
|||
|
|||
One quick question: Why do you need 3.5" exhaust?
|
#7
|
|||
|
|||
Dart,I'm upgrading to 2.0 in. headers(Hooker Super Comp.)with 3-1/2 in. collectors on a new combination with Indy SR setup from Muscle Motors.Computer estimates HP to be in the 650+ range!Will be run on friday nite street legal races-(licenced,inspected,insured and thru the mufflers)
Am lookin for every tenth I can get in order to qualify for the quick 8(top street)This is getting tougher to qualify for every year!! Mike |
#8
|
||||
|
||||
3 inch should be big enough.
just my 2 cents... |
#9
|
|||
|
|||
If your intrested I'm going to remove my 3.5" exhaust with the larger case Dynomax 6" welded race magnum mufflers. These are good for the track, but a bit too loud for me.
These are connected to the hooker 2" super comp headers on my 451 stroker. The car is a "b" body '71 Charger and the exhaust dumps at the rear axle with turn-downs. I paid way to much for the 3.5" system (about $450!), but If it will fit your car I'll sell it for $300. I also have a set of the smaller (louder) 3.5" Dynomax 4" race magnum bullet mufflers that I'll sell if your intrested. [This message has been edited by 451Mopar (edited January 12, 2001).] |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
larger tires | WA-Mopard | Dakota Truck Forum | 5 | 12-26-2004 11:08 PM |
Looking for 426 or larger Hemi | viper2 | Rear Wheel Drive - Parts for Sale | 0 | 08-27-2003 07:14 PM |
Anyone upgrade to larger brakes? | ram360 | Ram Truck Chat | 5 | 10-07-2002 11:11 AM |
can i go larger on the tires | patdak96 | Dakota Truck Forum | 5 | 05-14-2002 11:31 PM |
Larger Tire Size | Keith AP | Ram Truck Chat | 5 | 10-26-2001 10:32 AM |