|
#1
|
|||
|
|||
I recently upgraded my 8.75 rear end to a Wilwood system. I also replaced the original master cylinder (with booster) with the recommended Mopar Performance master cylinder. The new mc does not have the booster or the same fitting that mounts to the bracket on the firewall. What adapter is required to make the new mc fit onto the original location? Thanks in advance.
------------------ Duster Bob - Redondo Beach, CA |
#2
|
|||
|
|||
Zippy Makes one. Its like $30. Here's the pic of it
his e-mail is zscamp@aol.com hope it helps ------------------ Goldduster '70 Duster 318 2bbl http://duster.svhost.com/duster70?REC=0 The Plymouth Duster Homepage http://duster.excelland.com?REC=0 [This message has been edited by goldduster (edited January 26, 2001).] [This message has been edited by goldduster (edited January 26, 2001).] |
#3
|
|||
|
|||
Go visit http://www.ARengineering.com and you'll see the necessary adapters as well as heatshields. Or go to the Moparts.com board and check out Zippy's ad over there.
(BTW - the one GoldDuster shows isn't Zippy's adapter, but it is the general idea) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Master Cylinder ?????? | Jack_440 Savoy | Performance Talk | 12 | 04-02-2007 12:07 AM |
best master cylinder | viper11 | Performance Talk | 11 | 02-12-2005 02:26 AM |
master cylinder | dartgt340 | Vintage MOPAR chat | 5 | 12-28-2003 11:13 PM |
master cylinder | gregok | Restoring your MoPar (Tricks & techniques) | 5 | 12-09-2002 06:07 PM |
master cylinder | JoeM08 | Performance Talk | 0 | 04-17-2000 07:53 PM |