|
#1
|
|||
|
|||
I'm running low tension oil rings on my sreet/strp 340, would a exhaust type crank evac. system be enough or should I step up to a vacuum punp.
|
#2
|
|||
|
|||
It really depends Gearhed on your compression ratio and max rpm,you may not need one at all if your 10:1 with a redline of 6000 rpms or less,it wont hurt to run one either,most oil rings are low tension,there are some that are less tension then stock be sure which you have......PRO.....
|
#3
|
|||
|
|||
The rings are total seal gapless, total seal gives you a choice of standard tension or low tension. I'm running roughly 11.3 compression, and looking to turn anywhere from 6800-7200 through the traps...GEARHED
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Identify: Forged Crank Verse Cast Crank | tomjs23u | Performance Talk | 23 | 06-02-2010 03:57 PM |
March Performance Pulleys for 94 -> 97 (some 98) Crank and water pump only | SweetnLow | Trucks - Parts for Sale | 8 | 03-28-2002 08:06 PM |
Steering pump/box for sale, crank too | cdignition | Rear Wheel Drive - Parts for Sale | 3 | 05-09-2001 08:31 PM |
Eagle 'RB' 4.15 Stroker Crank VS. MP 4.15 Stroker Crank VS. Welded Stock Steel | krownman | Performance Talk | 5 | 03-04-2001 11:47 PM |
The New Eagle Crank VS. MP Crank VS. Welded Stock Steel Crank | krownman | Performance Talk | 0 | 03-03-2001 09:26 AM |