Stupif Question...Damper Problems...HELP - Moparchat

TwiZtiD440 · #1 03-07-2002, 12:11 AM

Ok, I'm no expert at this, only did it once on a brand new 4 banger engine, but I'm having problems removing the damper. Should I be using a larger puller? Am I grabbing from the wrong spot?

Cameron's Racing · #2 03-07-2002, 12:37 AM

Wrong type of puller. You are using a gear puller. You need a puller that will bolt to balancer.

Hope this helps.

pishta · #3 03-07-2002, 12:42 AM

Yes, you are pulling from the wrong spot! See those bolt holes around the crank bolt hole? Thread a few and pull on those. If you can rent a puller, even better.

JVMopar · #4 03-07-2002, 01:14 AM

You can get a puller for real cheap. Like the others have said it uses the bolt wholes for the crank pulley. I don't think you'll get it off trying to pull it like that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BHJ Damper	lxrubin	Performance Talk	3	02-14-2009 03:05 PM
BHJ damper	george a nilsen	Performance Talk	11	02-26-2004 02:28 PM
Fluid Damper Question??	george a nilsen	Performance Talk	23	12-11-2003 03:08 AM
Which damper for my 360???	440cj	Performance Talk	29	11-06-2002 11:00 PM
Cherokee (death?) wobble, and vibration damper question	John Phillips	Jeep Chat (Wrangler, Cherokee, etc...)	3	09-08-2001 02:29 PM