|
|
|
|||||||
|
#1
03-14-2002, 08:52 PM
|
|||
|
|||
Help! Just installed Lakewood B-Housing,now Z-Bar won't fit?
From housing to frame it seems to be too long. Am I supposed to cut to fit? Am I doing something wrong? If I cut it ,won't that throw the geometry off on the clutch linkage? Anybody been here done this,hopefully?
|
|
#2
03-16-2002, 12:07 AM
|
||||
|
||||
I installed 1 one the s/b in the '73 Cuda. It was a little tricky, but it fit without any real problems.
|
|
#3
03-16-2002, 01:11 AM
|
|||
|
|||
|
OK?...
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lakewood scattershield | clarkj | Circle Track Chat | 0 | 04-20-2009 01:55 PM |
| Bbody 83/4 housing and axles to trade for Abody 83/4 housing | rrone | Rear Wheel Drive - Parts Wanted | 4 | 11-11-2008 12:38 PM |
| Small Block Lakewood bell housing users? | earlymopar | Performance Talk | 12 | 07-05-2006 10:47 AM |
| Who has a QuickD installed? Who has a Hughes Throttle Body installed? | TruckBoy95 | Ram Truck Chat | 1 | 08-10-2000 12:48 PM |
| lakewood bellhousing | 68rr | Performance Talk | 0 | 11-15-1999 07:08 AM |
Linear Mode
