|
#1
|
|||
|
|||
Steel 340 crankshaft
Can a crank be repaired? Magnafluxing revealed a crack in #1 rod journal radius. I was told immersion welding can be used to repair damaged cranks. Anyone have experience with this?
|
#2
|
|||
|
|||
It sounds hokey to me. I would get a new crank. A crank is very highly stressed. Once a crack starts, it will continue until it breaks through. It will cost more than the crank if you blow up your engine.
|
#3
|
|||
|
|||
steel 340 crank
Have a good shop pre-heat, and weld the radius.( fill the undercut fillet). If unsure of their mettalurgy, tell 'em to use stainless. Then regrind using an .060" radius, stronger, and a good fix up to approx. 500 H.P. Just my 2 cents.
|
#4
|
|||
|
|||
A lot depends on how hard the crank will be used. It's not uncommon to find shallow cracks in the radius fillet, sometimes they're only a few ten thousandths deep and won't cause a problem in a near stock motor.
|
#5
|
||||
|
||||
crank repair is possible, but frankly, i wouldn't rebuild a motor with a refurb'd crank. I would put the money down for a new or undercut used one (just for piece of mind)
.sbuc72 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Steel crank 383s, and steel crank440 + more | 73scamp318 | Rear Wheel Drive - Parts for Sale | 3 | 05-24-2006 09:54 PM |
high quality t-304 stainless steel or mild steel that has been ceramic coated | desktopsilver | Ram Truck Chat | 2 | 08-17-2003 10:52 AM |
Pistol Grips Exotic Woods/Stainless Steel, Cuda vert moldings, humps, steel scoops... | cuda71pe | Parts for Sale | 0 | 07-16-2003 08:26 PM |
Looking for a crankshaft | Racedude_5 | Circle Track Chat | 4 | 05-23-2002 09:45 AM |
crankshaft | iron_will | Circle Track Chat | 3 | 12-31-2001 04:31 PM |