|
#1
|
||||
|
||||
10 to 11 inch drum swap ?
Anybody got a hollender manual ???? I want to swap a set of 71' 11" hd drums onto a 67 belvedere II that is currently running 10" drums. Will the parts bolt on in front, ( this is a full set - backing plates to drums on all four corners. I have the spindles too)..or do I need change spindles in front or what???
Thanks, RC |
#2
|
||||
|
||||
I.ve done the rear before, it's a snap. Just transfer baking plates and applicable hardware.
On the front, I now when I've done 9" to 10" Ive had to change the spindles, but that was on an A body. I would Plan to do the spindles, as you will probably find a difference in them, while doing the job. Ie a mounting point for something in a different place |
#3
|
|||
|
|||
The Hollander shows '70-'72 B body drum brake knuckles as different than the '62-'69.
I know that they physically interchange so the difference must be in the backing plate bolt pattern. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drum brake swap | ibcuda | Vintage MOPAR chat | 5 | 02-01-2008 12:58 AM |
A-body 10 inch drum spindles | 71dart666 | Rear Wheel Drive - Parts Wanted | 1 | 05-05-2005 07:47 AM |
drum brake help, frankenstein 9.25" swap | horatio102 | Performance Talk | 6 | 04-21-2004 05:08 PM |
Need front brake Drum for 74' Duster 10 inch small bolt pattern | jkailholz@aol.com | Rear Wheel Drive - Parts Wanted | 1 | 12-30-2001 04:22 AM |
E-body disc/drum brake swap | ibt | Restoring your MoPar (Tricks & techniques) | 3 | 10-09-2001 11:58 PM |