|
|
|
|||||||
|
#1
01-29-2000, 09:01 PM
|
|||
|
|||
Does anyone have instrucions on how to remove the interior door panel.
|
|
#2
01-30-2000, 05:47 AM
|
|||
|
|||
Go to www.crutchfield.com they can give you some info and also set you up with the right tools you need.
Joseph
|
|
#3
02-19-2000, 01:07 AM
|
|||
|
|||
|
What kind of car do you have? I am pretty sure that most Mopar cars/trucks are the same in how the door panels are put on. To take the panels off of my 85 Ramcharger, the door handle has to be taken off, and the loop that you use to close the door. Then you slide a screwdriver around the inside and pull the springs out of the holes in the metal.
|
|
#4
03-05-2000, 09:37 PM
|
|||
|
|||
|
Removing the panel depends on what year you vehicle is. Just be careful of two things; 1.) Make sure it is fairly warm outside (or in the garage,) because the clips and panel, if both are plastic, are very easy to break.
2.) If you use a metal panel-puller, wrap the end with electrical tape to avoid scratching the metal on the door. Good luck! -xtant
|
 |
|
|
Linear Mode
