|
#1
|
|||
|
|||
Sittin' too High(Caltracs)
Just Installed Caltracs and rear of car is too high, especially on pass side. Is there something that I did or didn't do? I thought maybe I needed to loosen the U-bolts again and lower the car all the way down on the springs b4 I tighten the u-bolts again. Any help or ideas from you guys would be greatly appreciated. I want to get it right b4 the weekend. Thanks' Wedgehead
|
#2
|
|||
|
|||
Did you install the pivot point correctly, the leaf resides sandwiched between the pivot point and the bolt for preload goes over top of the springs, the only other thing would be you have too much preload on the springs. My car didn't change in height at all untill I preloaded the springs, hopefully I worded this right.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted new or used caltracs | snowman340 | Rear Wheel Drive - Parts Wanted | 0 | 03-04-2007 05:16 AM |
CalTracs | terrytckl | Performance Talk | 1 | 09-08-2004 07:52 PM |
Caltracs/Wheel hop!! Help!! | wedgehead | Performance Talk | 1 | 06-03-2002 04:49 AM |
Caltracs Installation | wedgehead | Performance Talk | 3 | 05-12-2002 02:16 PM |
Caltracs and Hotchkis | Sheffy | Dakota Truck Forum | 0 | 01-06-2001 05:03 PM |