|
#1
|
|||
|
|||
My 72 Dart motor
Picture of dart motor.360 crate short block with Ebrock heads.Hughes Cam kit and a M1 single plane w/ holley 800dp.
|
#2
|
||||
|
||||
Your focus is a bit out, but if it runs as well as it looks, somebody's gonna have some fun!!!
|
#3
|
|||
|
|||
I am dizzy ! Need a better pic.
|
#4
|
|||
|
|||
I put a 451 (400 block, 440 crank) in my Dart. It runs 10.27 at 129 mph!
|
#5
|
||||
|
||||
Beeman;
Is this the motor you wanted me to desk top dyno? Dispite the blurr it looks good. Tell the driver to slow down a little more so you can get a better shot. |
#6
|
||||
|
||||
thats nice lookin. nice job beeman
|
#7
|
||||
|
||||
for those of you that didn't see the thread " better picture" here it is.
|
#8
|
|||
|
|||
72 motor
Rumblefish yes thats the motor i want to desktop dyno. And my picture can be seen alot better if you cross your eyes when viewing Se ya at carlisle!
|
#9
|
||||
|
||||
impressive!!
|
#10
|
||||
|
||||
OK cool. I'll run it. I just need the valve size's and lift which I assume are 2.02-1.60, 1.5 ratio, comp ratio and cam spec. The cam card should have what I'm lookin for. I tryed the Hughes site and couldn't find the cam you listed. Looking for timing events.
E-mail me with it if you can. |
#11
|
||||
|
||||
Desk Top Dyno Results
Ah-Ha! Found the cam and ran it as a 10-1 comp with stock Edel. flow numbers.
________W/mufflers_______________W/O mufflers ________HP____Torque____________HP_____Torque 2000____84_____219______________98_____257 2500____119____250______________136____285 3000____154____269______________173____302 3500____205____308______________225____337 4000____264____346______________284____373 4500____319____372______________340____397 5000____366____385______________390____410 5500____398____380______________425____406 6000____418____366______________450____394 6500____417____337______________454____367 |
#12
|
|||
|
|||
Desktop dyno
Rumblefish i'm using crane roller rocker with the 1.6 ratio. Thanks Beeman.
|
#13
|
||||
|
||||
For headers W/O mufflers
Re-adjust peak power to 460 @ 6500rpm & peak torque to 414 @ 5000rpm.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
73 Dart motor | Gerhard Heim | Rear Wheel Drive - Parts Wanted | 0 | 10-29-2011 04:53 PM |
getting motor back in place after installing new motor mounts | bambam | Restoring your MoPar (Tricks & techniques) | 6 | 06-20-2004 05:33 PM |
Motor Mounts/ Motor straps??? | DAKRACER | Dakota Truck Forum | 0 | 06-04-2002 08:20 AM |
anyone who's replaced their motor or knows anything about magnum motor prices | RufusTheRam | Ram Truck Chat | 8 | 09-07-2001 05:16 PM |
Hennesey Motor sports and Viper motor in your 'GO | RAM MAN | Durango Chat | 0 | 01-06-2001 10:53 PM |