Looking for a real clutch

[dirty dan]

I am tired of tearring the center out of clutch disces. And when pulling the bell housing I hate it when I find Hiary looking spaghetti that use to be the contact surface. It`s no fun to pull the dust cover and find peices of steel and springs. My question is this Who in the whole wide world makes a clutch that will take the load,not slip and stay together under Xstream use and abuse??? I would like to hear from anybody and ervery body on this one. all replies are appreciated Many thanks Dirty Dan

[turbododge]

My new McLeod Street Twin was shipped (finally) yesterday and should be here Monday. McLeod says it should be able to hold the TT340 with no problem. Supposedly good for up to 900 hp and still very streetable. We will see.

[dirty dan]

Thanks for your reply. could you give me the part # and any spec`s you may have.

[pishta]

Mancini has the whole Centerforce line advertised, the ricers like them. 900 Horse behind a 4 speed, yeah...for how long?

[dewme5]

think he said the clutch was good for 900hp, not the tranny.

[Mopar_Mudder]

I have run the Centerforce Dual Friction 11 and 12 inch in my truck. 440 with about 500hp, 38" tires, 4:88 gears. 4 Wheel traction and lots of torque, can't think of much harder on a clutch. Both held up perfect, never a problem, never a slip.

[dirty dan]

A12" clutch? I was unaware such a thing was avilable. What are you useing for a fly wheel ? Is it a factory peice? Is it strictly a truck application or will it fit inside the car bell? thanks for the info.

[Mopar_Mudder]

I don't know if it will fit in a car bellhousing, but the 11 & 12" have the same bolt patern, so I would think that if an 11 does a 12 should also.

[dirty dan]

thanks again Iwill have to do some checking around on the fit.