Tip concerning 1.6 ratio rockerarms for mopar 383,,,what to chose?

[Olle B]

Hi
Im planning to buy a set of 1.6 rockers for my 383 HP 1970 engine!
It must be adjustable and for hydralic original lifters!

Any tip of model and supplier?

Is it possible to use original two sided ball end pushrods with any known model on the market?
I run with a moderate original purple RR cam and the reason for asking is thatt my old rockers are so wear down and flexable I just have to buy new and perhaps take the chance of an upgrade!
Best regards Olle B

[1972roadrunner]

i don't think i've seen any adjustable rockers that were male-male (balls on both sides). i would go ahead and use the male-female (ball on lifter side, cup on rocker side).

i would use either Crane, or Mopar Performance rockers...whatever is available. i WAS going to use Crane, but i didn't wanna wait another 6 weeks... so i went with Mopar Performance. they look good, and work. no problems with them yet.

i think you'll like the performance difference from 1.5 to 1.6....it is very noticeable! i love it!

have fun, and good luck Olle!