|
#1
|
||||
|
||||
Lookin for a good Machinist
Hey Ya'll,
I was wondering if anyone out there can tell me where to find a decent machine shop in western washington that knows about mopars (specifically 383's) I am trying to find someone with a little bit of experience on blocks besides the average chevy hack shops Ive been pointed towards. Thanx, Tuffguy |
#2
|
|||
|
|||
If worse comes to worse, and you can't find a good one close by, there are a couple down here - Drummond Auto Machine and Custom Machine. If you need more detail, let me know.
|
#3
|
||||
|
||||
Thanks Doug, I appreciate the offer. about how far are they from the Seattle area. Here is my E-mail if you want to write back that way so we don't hog up the web page. jjbellis@gte.net
T. G. |
#4
|
|||
|
|||
Hey Doug I'm Looking for a good machinst too. What was the phone number for custom machine?
|
#5
|
|||
|
|||
I use Gray's Automotive in Tigard OR. Just a few miles SW of Portland. They have a dyno and they build a lot of Mopar engines. They've done several stroker motors for me. They also do a lot of Chevy circle track motors but I don't hold that against them.
|
#6
|
|||
|
|||
The best small block man I know is in the Seattle area Larry Hollums. 600 horse 340 Super Stock motor with one worn out old Thermoquad on top. I am not sure of the town but one around Tacoma. Maybe somebody on here has his number. Jay
|
#7
|
||||
|
||||
Hi tuffguy
just a thought check out local stock and super stock racers, they might be of help. they gotta have someone local. Denny |
#8
|
|||
|
|||
You are always better off if you can find a quality MOPAR shop close to home.
|
#9
|
||||
|
||||
Thanks guys, I think your right I am still looking, but I would much rather find somebody near home. When I find somebody good I will let everybody here know if anybody is interested.
|
#10
|
|||
|
|||
If you find one, let us know.
If you don't, I'd be willing to meet you and take you to the one close to me. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
lookin for a 3.9 | lowdkota | Dakota Truck Forum | 6 | 01-22-2009 02:33 AM |
The Machinist | Ray Bell | Performance Talk | 10 | 11-04-2006 02:02 AM |
Lookin for a lil help | Diznax777 | Jeep Chat (Wrangler, Cherokee, etc...) | 2 | 02-05-2004 12:05 AM |
Need help finding machinist in Phoenix for crank work | 69Coronet4evr | Performance Talk | 2 | 01-03-2004 10:46 AM |
NEED a machinist in the Atl GA area...and some opinions | danmaloy | Performance Talk | 8 | 10-03-2002 10:24 AM |