|
#1
|
||||
|
||||
Drive shaft length!
Ok Whats the least amount of length I can get away with! My drive shaft yoke goes in my tranny tail about half way! So i figured about 2.5 inches that the splines meet! Will this be enough? I have a 4.30 suregrip and a 727/360 Duster!
|
#2
|
||||
|
||||
shaft length
six; jack the back your car up and put jack stands
under the axle tubes. Leaving the weight on the springs. Remove the universal joint straps. Then slide the drive shaft into the trans as far as it will go. Messure the distance the drive shaft has moved from the yoke ,then subtracket 1" . This will tell you how much to add to your shaft to get the proper length. I know this doesn`t really answer your question. But the drive shaft is either right or wrong. However you should Know that mother made more then one drive shaft yoke for the 727. There were 2 that Iam aware of the shorter of the 2 is most common. The exact amount of added length I don`t recall. But it is enough to pick out in a crowd. A trip to the bone yard and a look through the pile of drive shafts may be helpfull. Happy trails |
#3
|
|||
|
|||
My friend, you will need the drive shaft to be the correct length half way is not gunna get it, if the shaft is too short , your gunna get vibration and it will hammer your trans tail shaft and the posiblity of having the drive shaft drop out and pole volt you into the next state, be really good to yourself when it comes to something that takes the stress and torque everytime you hit the gas.
yer bud coolcarz |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drive shaft length | dirttrackracer | Performance Talk | 4 | 04-23-2006 09:57 AM |
Drive shaft length | PlumDemon | Performance Talk | 1 | 02-13-2006 08:13 PM |
Drive Shaft length | bwlizard | Performance Talk | 8 | 06-17-2002 12:32 AM |
Drive shaft length | dave&leighdavis | Performance Talk | 2 | 01-07-2001 10:03 PM |
drive shaft length | steve5654 | Vintage MOPAR chat | 1 | 05-14-2000 06:35 AM |