|
#1
|
||||
|
||||
who's right or wrong
what is the right thing to do? The hanes engine manual says that on a rb (440), when installing the manifold, you only use the valley pan with sealant on it. But when you buy the felpro manifold installation kit it has both the embossed pan and the 4 felt gaskets in it. Do I sandwich the pan with the gaskets or just use the pan, wich does have the embossed groves around the intake holes, with brush tack and sealant? Its an aluminum manifold if that matters.
|
#2
|
||||
|
||||
Hmmm...so strange,
I've never bought a Fel-PRo valley pan for my 440 that came with anything but the sheetmetal valley pan and a little tube of sealant. Any way thats all I have ever used anyway. A little sealant at the front and rear where the metal strips bolt down and torque the bolts properly..no problems for me. |
#3
|
||||
|
||||
Every felpro pan that have have ever bought only came with the pan and the brush tack.
|
#4
|
||||
|
||||
OK that is what I was going to do anyway. Thanks
|
#5
|
||||
|
||||
It was felpro part #fpp-1214 I bought it from summit. I also got one from the local shop before, same thing it has 4 felt gaskets.
|
#6
|
||||
|
||||
oooh i see...the 1214 has the heat crossover ports blocked off. Same proceedure should still work the same.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What am I doing wrong? | poboyrr | Vintage MOPAR chat | 5 | 03-19-2007 02:00 PM |
This is just WRONG! | King_Valiant | Hunting & Fishing | 7 | 01-02-2005 09:54 PM |
S.O.S ---- What I did wrong ? | Mopar Brasil | Performance Talk | 7 | 08-30-2004 05:00 PM |
What's wrong with my 4sp.? | Drews'70 | Performance Talk | 6 | 11-21-2003 02:04 AM |
Help I am not sure what is wrong | Mahtipsey | Front Wheel Drive Chat | 1 | 04-08-2002 05:36 PM |