|
#1
|
|||
|
|||
Intake Valley Cover
I have an Offy tunnel ram on my 440 and was wondering if anyone made a intake valley cover?
Thanks...... |
#2
|
||||
|
||||
Just the valley pan. You don't need anything else down there.
|
#3
|
||||
|
||||
Actually I wanted to ask the same question. I've seen a neat looking aluminum piece on a few cars with Indy & Stage VI Heads. Anyone know where to find this and will it work with stock or EB heads?
Later, Greg |
#4
|
|||
|
|||
On some of the earlier big blocks there was a silver like material in a pillow type configuration on the bottom of the factory intakes. Or is this something else you are talking about.
|
#5
|
||||
|
||||
It wouldn't take much to make something. It would just be a rectangualr piece of thich aluminum. It would just cover the valley pan and would only be held in by the bolts that the oil rails in place. You could probably use this to replace the oil rails, for a cleaner look.
|
#6
|
||||
|
||||
Indy makes a cast aluminum unit for RB's, not sure about B's. I would just make one out of 1/8" aluminum plate, though.
|
#7
|
||||
|
||||
vally cover
Should you decide to make your own.
Keep in mind that it is not a true rectangle. That is to say the corners are not 90`s. Also bevel the top edges on the long sides to prevent clerance problems for the intake. The best way to do this is to use the center of the valley pan as a templet. Hope it helps Dirty Dan |
#8
|
||||
|
||||
The covers are in the mopar performance catalog.
|
#9
|
||||
|
||||
I'm looking... got a part # ?
|
#10
|
||||
|
||||
P4876848 - RB Valley Tray $34.90 through Earnhardt's dodge in AZ
Now, what do you use for an intake gasket if you use this tray? Thanks, Greg |
#11
|
|||
|
|||
Thanks GSMOPAR!!!! With the current tray it collects lots of water when we're on the the river.
|
#12
|
||||
|
||||
These guys kick butt! So if you're doing the mail order thing... I'd recommend them!
Earnhardt's Dodge |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valley Pan AND Intake Gaskets? | GA67GTX | Vintage MOPAR chat | 12 | 03-04-2008 01:22 AM |
Hughes Two Piece Valley Cover | fatman | Drag Racing Forum | 0 | 01-29-2006 11:36 AM |
Valley pan or intake gaskets? | pishta | Performance Talk | 7 | 11-16-2003 11:54 PM |
Intake valley tin gaskets? | Marvin S | Performance Talk | 4 | 04-21-2003 09:06 PM |
Modding an Valley Pan to keep oil off intake? | sereichling | Ram Truck Chat | 0 | 07-30-2001 12:47 AM |