|
#1
|
|||
|
|||
Nitrous on a TBI 318 in 4x4 Ramcharger
The motor is a '91 318 with magnum block with pre-magnum heads, same as on a 91 360.
.040 rebuild 9.0:1 TRW foged pistons crane hydraulic roller 204i,214e duration @.050 w/.470,.500 lift full legnth headers with O2 sensor mounted just behind reducer. Truck weighs approx. 6000+ 3.54 gears (soon to be 4.10 and from 31in tires to 33in tires) engine builder says it is good for a 100HP shot, maybe 125HP shot except that it is my daily driver, or be on the safe side with a 75HP shot. (should have installed splayed maincaps on the center 3) how do i build a plate to go under TBI or put a couple of fogger nozzles over the throttle body? How do i figure out how big of jets i need also. |
#2
|
||||
|
||||
I think Nitrous Works makes a universal kit for EFI engines.
EFI Wing Kit Or you could always go with a direct port kit. Later, Greg |
#3
|
|||
|
|||
Thanks, it looks like the best idea so far. the 318 is a very under rated motor, but I know quite a few small block chevy trucks that have learned to respect mopar the hardway.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
what makes a nitrous motor a nitrous motor? | Chache876 | Power Adders | 14 | 01-05-2005 05:28 PM |
Nitrous | lucky13 | Dakota Truck Forum | 11 | 04-29-2002 09:56 PM |
Nitrous | 5.9Magnum | Durango Chat | 7 | 05-20-2001 09:23 AM |
Nitrous? | Fastdak | Dakota Truck Forum | 8 | 01-08-2001 04:59 PM |
nitrous | duane_koda | Ram Truck Chat | 3 | 05-27-2000 01:32 AM |