|
#1
|
|||
|
|||
Advice needed
Hey you all, I have been a mopar lover for years and finally have my own, a 69 dart swinger. What I need to know is what rearend would you all recommend for street use with about 300-350 hp.
Th car has what i have been told is a 71/4. Will this work or will I have to find something else. I have a 68 dart gt also that i purchased for parts how can i find out what rear is under it. Thank you for any help you could offer. |
#2
|
|||
|
|||
Go with a 8-3/4, sometimes hard to find, and expensive. I started with only an a-body bare housing, had to purchase everything. If your 68 GT had a 340 it should be an 8-3/4, probably a 7-1/4 if any other motor. Good Luck
|
#3
|
||||
|
||||
Unless that GT is in real bad shape, I would gut the swinger into the GT.
If the bolts are in the front of the diffy, holding in the gears, it's an 8¾. If the bolts are in the back holding on a cover, then it's either a 7¼, 8¼, or a |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Advice Needed | Southwestmale123 | Slant Six Chat | 4 | 02-24-2008 08:14 PM |
Advice Needed/did I Screw Up? | jimbo87us | Rumors and Gossip, etc... | 3 | 11-28-2002 12:19 AM |
tranny advice needed | 7yr | Vintage MOPAR chat | 1 | 06-20-2002 12:18 AM |
Advice needed . . . | Blaine Peterson | Ram Truck Chat | 9 | 03-20-2002 10:45 PM |
Advice on a v10 needed | Thornbird | Ram Truck Chat | 3 | 11-24-2001 01:42 AM |