|
#1
|
||||
|
||||
Challenger Problems
I need to know what transmission yoke I need for my small block 727 tranny.
Do I need the 29 spline 7290 yoke or the 29 spline 7260 yoke Also, what length driveshaft do I need for this application? challenger: 360, 727 tranny and an 8 3/4 rear end thanks |
#2
|
||||
|
||||
7290 yoke = big U-joint
7260 yoke = small U-joint Driveshaft length I don't know. But there are companys that you can purchase a driveshaft ready made to fit your car. Seeing that it is a stock configuration, it's an easy call. The local drive shaft shop would be the better bet. If it's not to hard to get to. |
#3
|
|||
|
|||
driveshaft length
I just took the measurement you need off my 74 Challenger 360 727 8.75 rear,and it came out to 45.5 in from the center of one u-joint to the other.Hope this helps!
|
#4
|
|||
|
|||
You should have measured mine while you were here. I have the combo 7260/7290. Yes, the 340 will live next year. And this time the block will be the correct color. Yup, its a 318.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
challenger wiper problems | 71forestgreen | Vintage MOPAR chat | 2 | 11-09-2008 02:11 PM |
Coincidence: heating problems and electrical problems??? | ttraut@unlockit | Performance Talk | 12 | 07-14-2002 07:04 PM |
Problems With 1970 Dodge Challenger | narfmasta | Performance Talk | 24 | 04-13-2002 03:05 PM |
challenger ???? | 72 CHALLENGER BOY | Vintage MOPAR chat | 0 | 05-28-2001 12:39 PM |
N VA/DC/MD 400 Challenger to Look At | 440Challenger | Vintage MOPAR chat | 0 | 01-31-2000 04:58 PM |