|
#1
|
|||
|
|||
Rebuild kit for NP208T???
Hey guys.
My '85 Ramcharger has some slop in the output shaft of the transfer case. At first it was the typical BANG when you go from forward to reverse. Now it does it when you are driving and let off the gas. It seems to be getting worse as time goes on. (Before you say "Did you check them U-Joints?" the answer is YES) The truck is almost 18 years old now and it is probably time to pull it out for a rebuild. Is there a kit out there for it??? It is the NP208T which is the part time chain drive case. I was told it is the best of the chain cases they used. Other than the BANG from the output shaft it works fine. I had the driveshaft out once and you can turn the output yoke on the xfer case amost a quarter turn with the truck in park. I imagine it is worse now. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebuild! | DANS66DART | Slant Six Chat | 4 | 03-28-2003 08:49 PM |
318 rebuild | 88dippy | Performance Talk | 14 | 03-18-2003 06:59 PM |
Will a 518A tranny mate to a NP208T xfer case??? | Dr. Righteous | Ram Truck Chat | 5 | 11-30-2002 10:41 PM |
318 rebuild | ndw2832 | Performance Talk | 9 | 09-27-2001 02:26 PM |
360 rebuild | Doobiemon | Performance Talk | 1 | 09-20-2001 05:11 PM |