|
#1
|
||||
|
||||
A-arm mount mod for HEMI
Am prepping the 65 Belvedere for the install of the HEMI. I've seen 2 different references to the clearance mod made to the pass side upper a-arm mount, but can't tell from the info or pic what is done.
Anyone know for sure, and where to get the info needed? I want to get this done B4 I paint the engine compartment. Question 2. I am also adding the disc brakes and the late MOPAR perf. M/C. I saw where someone had used flex lines from the M/C to allow for moving the M/C out of the way for valve cover removal. Anyone know how this is done, and what's needed to do it?? Part numbers? Sources? As I recall the M/C ports were on the fender side of the cyl. Thanks for the help!! |
#2
|
||||
|
||||
I am not sure, but you might give my friend Dan Cook a call. He is a Hemi guru and runs a HEMI powered 65 Coronet which should be the same set up you are looking for.Dan Cook Racing Good Luck.
|
#3
|
||||
|
||||
Thanks!
Vann, thanks for the reference. I'll call him next week.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low Mount HIAMP Alt mount w/ engine plates | OHD | Performance Talk | 0 | 12-22-2007 07:21 PM |
transmission mount | Cudadrag | Performance Talk | 29 | 10-11-2006 01:21 PM |
Gm 10 si alt mount for 360 | cageman | Performance Talk | 2 | 04-03-2002 08:46 PM |
CB mount | 01ramoffrd | Ram Truck Chat | 2 | 12-04-2001 02:10 PM |
best way to mount KC's | Youngin | Ram Truck Chat | 5 | 09-08-2000 01:48 PM |