440 push rods

[1fastski]

i bought a set of 1.7 roller rockers for my 440 ,almost stock beefy cam , i need to find cuped pushrods , having a problem finding them , if anyone knows where to get them let me know , thanks

[dave571]

I'm pretty sure they're in the MP Catalog.

I think the Mp valve train stuff is Crane.

[djswwg]

I bought a set of Crane's for my 440 earlier this year. They are very stout with a cup on the rocker end and a ball on the lifter end. Just be sure you order the correct ones for your engine-either hyd. or solid lifter, as the ball is smaller with the hyd. cam. Only reason I bought Crane- it was the cheapest at the time! And I don't see how paying more would make them work better......djs

[kcmopar426]

try this site for some push rods - u need to scroll down aways

this is the link http://www.flatlanderracing.com/manpushrods.html

[440Ramcharger]

Smith Brothers in Oregon.
1-800-367-1533

[b-1ken]

Is this a flat tappet cam? You had better be careful. Those 1.7 rockers will increase the load on your lifters by 13.3% over the 1.5's. Too much spring pressure could wipe the cam. Smith Bros. are real good with regard to quick service and a quality part. They'll cost you about $10 each though.

[DartGT66]

...and be sure to check the pushrod clearance in every pushrod through the whole valve travel.

[cuda66273]

Ditto

Smith Brothers in Oregon.
1-800-367-1533