|
#1
|
||||
|
||||
My new engine
Well my 360 is finally done.We bored it .60 over,opened up the combustion chambers and installed 1.60-2.02 valves.A fresh set of Hyperutectic flat top pistons, a Howards cam with matching springs topped off with an Edelbrock Performer intake with a 600 Eddy carb.The engine builder estimates 400 plus H.P. at the flywheel.I was wondering if the intake and carb are gonna be enough.Any suggestions?
|
#2
|
|||
|
|||
I think a Performer intake and 600 CFM carb are just right - for a mild 318. You're never going to see 400HP with that combo.
Go for the Performer RPM and a 750 CFM carb, preferably a Holley or Demon. A TQ with the correct adapter could work also, but you need more hood clearance. |
#3
|
||||
|
||||
sounds good eggy
But good luck with that edelbrock stuff,is it still in the box,can you return it?
|
#4
|
|||
|
|||
your motor is beggin' for a holley 750 dp. i can hear it from here lol
|
#5
|
||||
|
||||
DO NOT use the eddy if you can keep from it, but if that's all you have and can $$ right now use it but start saving for a better carb BG would be right up there at the top of the list or a TQ if it will fit you application.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seezed engine/ broken engine mount | moparots | Performance Talk | 4 | 03-04-2004 02:44 PM |
Power gain from worn out engine to proper machined engine? | 6 packin | Performance Talk | 2 | 09-23-2003 04:11 PM |
which brackets and pulleys swap from engine to engine? | Moulder | Performance Talk | 1 | 02-28-2003 07:21 PM |
engine hesitation - check engine light | farley | Ram Truck Chat | 2 | 01-29-2001 05:45 AM |
LHS engine and Intrepid engine, whats the diff? | brun064 | Front Wheel Drive Chat | 3 | 06-14-2000 05:35 AM |