|
#1
|
||||
|
||||
Sloppy pinion yoke ?
I have an 8 3/4 rear in my satellite with the small u joint pinion yoke as well as the drive shaft end. My problem is I can grab the drive shaft and by sliding it towards the front and rear of the car I can see the bearing cup sliding as well, about an 1/8" . When I installed the rear end I had the same issues and had the shop install what they said was a good used one. I tried putting a bigger u joint on but it definately wont fit. Was going to try the split u joint to adapt but thats not the issue. Could it be the straps are worn out or the pinion yoke ? Also will this cause vibration at a given RPM ?
|
#2
|
|||
|
|||
you need the clips on your u-joints. go to the parts store with one of your caps and they'll fix you up.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Large pinion yoke? | 345Dart | Performance Talk | 4 | 03-29-2005 05:52 PM |
Dana 60 pinion yoke | neller | Performance Talk | 1 | 01-06-2003 03:06 PM |
Sloppy Steering | naitram | Ram Truck Chat | 13 | 05-16-2002 05:02 PM |
27 Spline Pinion Yoke | 1972roadrunner | Performance Talk | 17 | 04-21-2002 04:08 PM |
Pinion yoke fit | Gromski | Performance Talk | 2 | 04-27-2000 01:18 AM |