|
#1
|
||||
|
||||
intake problem
ok i have a airgap intake on a 360 .i had the motor rebulit and the heads were done the block was sqared up and they said the heads were sqare also.put intake on and it sucked antifreeze ok so took it off got a new airgap put it on drove it for the summer then took it for a final drive before storage and just got in the driveway and it started again. took intake off and the two inner runners 4 and 6 were wet. iam useing rtv silicone front and back dowel pins are removed and even smeared some silcone around the runners .so i cleaned it up and just sat the intake on by itself it's got a little play at the back from side to side but front is ok ...................could it be the intake or somthing is not sqared..have read somthing about the great suff ...who makes it and where can i get some,,thanks
|
#2
|
|||
|
|||
take your intake to the shop and ask THEM to install it..if leaks, then they should know where to grind...
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
intake problem | cuda360 | Performance Talk | 13 | 10-20-2003 12:00 PM |
weired K&N intake problem | slammedR/T | Dakota Truck Forum | 8 | 08-30-2003 05:40 PM |
intake problem | cuda360 | Performance Talk | 20 | 07-17-2003 03:07 AM |
rocker arm/intake problem. help;; | a rodriguez | Dakota Truck Forum | 7 | 06-06-2002 05:41 PM |
Problem with K&N Gen II cold air intake | FireBat | Durango Chat | 12 | 07-10-2001 05:52 PM |