|
#1
|
|||
|
|||
where can i get a cheap floor hump for 4 speed conversion?
i'm planning on doing the 904 to 833od swap in my 1970 swinger. i need to know where i can get the floor hump for a good price. so far, keisler has the cheapest at $109. can anyone do any better? what about fiberglass? i'm not racing, so i'm not too worried about the tranny blowing up. thanks for your help.
casey |
#2
|
|||
|
|||
$109 sounds like a good price for a new one. You can spend that much for a rusty used one, if you can find them.
Does anyone make these humps for a '64 Valiant? |
#3
|
||||
|
||||
Check Year One, The Paddock, and Passon that makes the A833 trannies.
|
#4
|
|||
|
|||
I made one once out of an old FOR SALE sign, a 1 by 4, 100 sheet metal screws and a tube of silicone caulk. Good that it was covered by the Sparkomatic 4 by 6 rubber boot and floor mat as it was ugly. With that in mind I think the price sounds very good if it fits.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
4-speed hump | aa-1159 | Rear Wheel Drive - Parts for Sale | 0 | 07-22-2006 09:28 PM |
where can i find a cheap floor hump for 904 to 833 swap? | CaseDawg | Performance Talk | 1 | 05-24-2004 07:03 PM |
4spd tranny floor hump | Dale G | Rear Wheel Drive - Parts Wanted | 1 | 03-17-2004 12:28 AM |
4 speed hump location? | MAXINE-70 | Restoring your MoPar (Tricks & techniques) | 4 | 02-15-2003 12:30 AM |
b body floor hump wanted | MAXINE-70 | Rear Wheel Drive - Parts Wanted | 0 | 12-29-2002 11:07 PM |