|
|
|
#1
05-27-2004, 07:58 PM
|
||||
|
||||
dana 44
Would a dana 44 fit under my '74 swinger? I need to replace it beacause i have the 7 1/4 in there now.
 I measured the dana 44 flange-flange and is 52.5 inch's. Is that good? And i have 3.73 gears for it to. 
|
|
#2
05-27-2004, 08:37 PM
|
||||
|
||||
|
The dimensions chart I have says that the 7 1/4 for a 74 A body is 51.400" flange to flange. Your Dana would be about 1/2" long on each side. Dont know if that would be a big deal, maybe off-set rims would help??
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8 3/4 or Dana - Which is better??? | chargerfreak | Performance Talk | 2 | 03-15-2004 12:08 AM |
| Help with Dana 60 please | 72Challenger | Ram Truck Chat | 10 | 11-09-2003 05:16 PM |
| Looking For DANA! | cuda4406v | Rear Wheel Drive - Parts Wanted | 9 | 08-23-2003 12:10 AM |
| Is this a Dana??? | tooomuch2 | Performance Talk | 9 | 05-06-2002 09:04 PM |
| Help with a Dana 60 | 1963newport | Performance Talk | 2 | 04-29-2001 12:44 PM |
Linear Mode
