|
#1
|
|||
|
|||
CalTracs
Need some help with my CalTracs. When I had a snubber my 60's were some 1.7's to mostly 1.8's. With Caltracs I am at 1.9's and 1.8's. I adjusted them per the instructions, just touching the top of the spring and the lower hole on the front bracket. Any suggestions?
THX 440, 10.5cr, 850 Holley, 727, Drag radials, 12.1et @117 typical. |
#2
|
|||
|
|||
i have stock springs, rancho 5 ways and caltracs. mine are set top hole, 3 flats on right side, just touching on the left. i set my ranchos at 3 on the left and 4 on the right. i know i could get my set up better if it would ever stop raining. also if you havent done this, turn your bars around so their easier to adjust under the rear. mine shaved 3-4 tenths over the pinion snubber.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What shocks to run with Caltracs?? | Piranha-z | Drag Racing Forum | 3 | 04-28-2007 01:05 AM |
Wanted new or used caltracs | snowman340 | Rear Wheel Drive - Parts Wanted | 0 | 03-04-2007 05:16 AM |
Caltracs NOT working | moparmikey | Drag Racing Forum | 12 | 08-11-2002 11:46 PM |
Caltracs/Wheel hop!! Help!! | wedgehead | Performance Talk | 1 | 06-03-2002 04:49 AM |
Caltracs and Hotchkis | Sheffy | Dakota Truck Forum | 0 | 01-06-2001 05:03 PM |