|
#1
|
||||
|
||||
No spark again
With the ignition on, I'm getting 12v to the ballast from the ignition switch. I also get 5.7v to the + side of the coil. and I'm getting 1.3v at the - side of the coil. The ECU is good and so is the ballast resistor, they worked fine on my dart when I swapped them out. If I run a jumper wire from the battery to the + side of the coil I still don't get any spark. Bad Coil? I also ohmed out the dist and got the same value as my perfectly running dart. The coil I have on it is 8 years old but only has run 10 times.
|
#2
|
||||
|
||||
Check your reluctor to magnetic pick-up gap in the distributor, it should be .008" - .010". The pick-up itself could be bad. Is your ECU grounded good?
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No spark | platboy | Performance Talk | 4 | 02-08-2006 09:09 AM |
No spark | cageman | Circle Track Chat | 3 | 06-14-2003 03:35 PM |
No Spark - 70 383 RR | 71RT | Performance Talk | 4 | 06-29-2002 09:24 PM |
No spark with MSD 6AL | cuda6pak | Performance Talk | 11 | 04-30-2002 10:31 PM |
Too much MSD spark! | JoeGrapes | Performance Talk | 3 | 04-30-2002 01:01 AM |