|
|
|
|||||||
|
#1
04-08-1999, 07:20 AM
|
|||
|
|||
Christopher: Is it possible this is an Interceptor? HP would be higher in the Interceptor,right? We are building for a street "rod" not track. This is not a typical factory 440 like in Chargers or GTX.Has marking on block we have never seen before. In the number on block it has a symbol that resembles an iron cross. Any idea what that means? Thanks!! :-)
|
|
#2
04-09-1999, 12:13 AM
|
|||
|
|||
|
What did it come out of. It may be an early factory replacement motor. Need more input.
|
|
#3
04-11-1999, 04:47 AM
|
|||
|
|||
|
What that means is that Mercedes-Benz built it.I'm kidding!!!It really means that the crankshaft is undercut by.0001 on either the rod or main journals.In other words,if you have the maltese cross and M1 after it,then main journal #1 is undercut,likewise if it said R2 then rod journal #2 is undercut.It will only be for those journals only that are stamped on the block,NOT the entire crank.Also the info I gave you earlier was for the police engine,as the passenger car version made less horsepower!!!And my info came straight from Chrysler.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| for your info | supertuff#1 | Off-Topic Forum | 14 | 01-03-2009 09:25 PM |
| 273 info please | ram50rocket | Vintage MOPAR chat | 7 | 08-03-2006 07:56 PM |
| Throttle body info on Turbo 2 car info on upgrade needed..... | Mopard | Front Wheel Drive Chat | 5 | 01-30-2005 11:26 AM |
| Lots of good tech ?'s for engine guys! (w-5 info? indy info? max hp stock block?) | dizuster | Drag Racing Forum | 8 | 03-15-2002 08:54 AM |
| Pre 60's rear axle info and upgrades, much info out there? | Stoga | Restoring your MoPar (Tricks & techniques) | 3 | 11-06-2000 07:25 PM |
Linear Mode
